LG Air Conditioner NTC Thermistor - EBG61106803

Maintain the intelligent temperature regulation of your system with the LG EBG61106803 Air Conditioner NTC Thermistor. This Negative Temperature Coefficient (NTC) sensor acts as the primary thermal "probe" for your unit's control board. It constantly monitors temperature changes—typically at the evaporator coil or the air intake—and translates those readings into electrical resistance. This data allows the air conditioner to precisely manage compressor cycles, prevent coil icing, and ensure your space stays at the exact temperature you’ve set. If your unit is blowing warm air, short-cycling, or displaying sensor-specific error codes (like CH01 or CH02), this genuine replacement is the standard solution.

The EBG61106803 is engineered with high-sensitivity thermal resistors and a moisture-sealed, protective encapsulation. This robust design is specifically intended to handle the constant condensation and thermal stress inside an active air handler, ensuring long-term accuracy and preventing the signal degradation common in generic components.

1. Safety First: Turn off the air conditioner and completely disconnect it from the power source (unplug it or switch off the dedicated circuit breaker).
2. Access the Interior: Open the front intake grille and remove the air filters. The thermistor bulb is typically found clipped to the copper piping of the evaporator coil or positioned in the return air stream.
3. Trace the Lead: Follow the wire from the sensor bulb back to the electrical control box where it connects to the main PCB.
4. Disconnect the Old Part: Open the control box cover and carefully unplug the EBG61106803 connector. Note the specific routing of the wire to ensure the replacement is not pinched during reassembly.
5. Install the New Thermistor: Plug the new sensor connector into the dedicated port on the PCB. Route the lead wire along the original path and snap the sensor bulb securely into its designated mounting clip or holder.
6. Reassemble and Test: Replace the control box cover, filters, and front panel. Restore power and set the unit to a specific temperature to verify that the system accurately detects and maintains the thermal setting.

1. AC Temperature Sensor (NTC) – Part Number: EBG61106803
2. Precise Thermal Monitoring: Provides the accurate data needed for consistent and efficient cooling performance.
3. Resolves Diagnostic Faults: Effectively clears error codes related to sensor failure or open/short circuits.
4. Moisture-Resistant Design: Built to withstand internal condensation and prevent signal drift.
5. Plug-and-Play Installation: Includes a factory-standard connector for a secure, tool-free electrical connection.
6. OEM-Quality Part: A genuine LG replacement component calibrated to match the original factory resistance-temperature specifications.