No.	Error	Symptom	Cause
1	Water Inlet Error	IE	Correct water level (24.6kHz) is not reached within 8 minutes after water is supplied or it does not reach the preset water levelwithin 20 minutes.
2	Unblanced Error	UE	The load is too small. The appliance is tilted. Laundry is gathered to one side. Non-distributable things are put into the drum.
3	Drain Error	0E	Water is overflowing. (water level frequency is over 21.3kHz). If FE is displayed, the drainpump will operate to drain the water automatically.
4	Overflow Error	FE	Water is overflowing. (water level frequency is over 21.3kHz). If FE is displayed, the drainpump will operate to drain the water automatically.
5	Pressure Sensor Error	PE	The PRESSURE SENSOR ASSEMBLY is out of order. When water level frequency is consistently below 10 kHz or over 30kHz.
6	Door Open Error	dE1, dE2	Door not all the way closed. Loose electrical connections at door switch and PWB Assembly. The DOOR SWITCH ASSEMBLY is out of order.
7	Heating Error	tE	The THERMISTOR is out of order.
8	Locked Motor Error	LE	The connector (3-pin,male,white) in the MOTOR HARNESS is not connected to the connector(3-pin, female,white) of STATOR ASSEMLY. The electric contact between the connectors (3-pin,male,white) in the MOTOR HARNESS and 4-pin, female, white connector in the MAIN PWB ASSEMBLY is bad or unstable. The MOTOR HARNESS between the STATOR ASSEMBLY and MAIN PWB ASSEMBLY is cut (open circuited).
9	EEProm Error	EE	EEPROM is out of order. Displayed only when the START/PAUSE button is first pressed in the Load Test Mode.
10	Power Failure	PF	Machine is working, the power is supplied rapidly.
11	Suds Error	Sud	If the washing machine detects too many suds, it displays the error code and adds Suds Reducig cycle. This adds about two hours to the cycle time. If too many Suds are detected during spinning, the washing machine stops to help prevent leaking.
12	VIBRATION SENSOR ERROR	uS	Vibration sensor to break down
13	Breakdown Detergent Pump	Ed1	The amount of liquid detergent in the detergent reservoir did not decrease. After putting the detergent into the detergent reservoir, it was lft for a long time and the detergent hardened.
14	Open Circuit Pump	Ed2	The amount of liquid detergent in the detergent reservoir did not decrease.
15	Breakdown Softener Pump	Ed3	The amount of fabric softener in the softener reservoir did not decrease. After putting the softener into the softer reservoir, it was left for along time and the fabric softener hardened
16	Open Circuit Softener Pump	Ed4	The amount of fabric softener in the softener reservoir did not decrease.
17	Communication Defeft	Ed5	PCB does not work due to poor communication.
18	Drawer Open	OPn	Ther washer was operated without completely closing the drawer. The drawer was opened during the washer operation
19	Drain Error	0E	The load is too small. The appliance is tilted. Laundry is gathered to one side. Non-distributable things are put into the drum.
20	Water Inlet Error	IE	Correct water level (24.6kHz) is not reached within 8 minutes after water is supplied or it does not reach the preset water levelwithin 20 minut
21	Vibration Sensor Error	v5	Occurs when Vibration Sensor Communication is not working. Such as vibration sensor register setup error, removal, etc.
22	Wifi Error	nE	WiFi Modem is not connected.
23	Wifi modem error	nF	Wifi Modem Self Check function Error
24	Frozen Failure	FF	Supply warm water into thr drum and unfreeze drain hose and drain pump. Wet a towel in warm and apply to supply hose
25	Vibration Sensor Error	vS	Malfunction of vibration sensor. Replace the Vibraton Sensor.