Issue:- Dishwasher does not reach the normal water level.

Possible Causes & Solutions:

• Water supply faucet is turned off or not fully open - Open the faucet fully.
• Water supply hose is bent - Straighten the hose.
• Water inlet filters are clogged - Clean the filters.
• Water pressure is too low - Contact a licensed plumber.
• Leak-limiting hoses in use - Avoid using these hoses.
• Water supply hose is frozen - Disconnect and thaw with warm water.

Issue:- Dishwasher fails to drain properly.

Possible Causes & Solutions:

• Drain hose is kinked or clogged - Straighten or clear the drain hose.
• Drain pump filter is clogged - Contact an authorized technician for service.
• Drain discharge is too high - Consult a technician to adjust the installation.

Issue:-  Internal leakage detected.

Possible Causes & Solutions:

• Check for visible leaks and tighten any loose connections.
• Ensure that the dishwasher is level.
• Contact a service technician if leakage persists.

Issue:- Oversudsing caused by improper detergent use.

Possible Causes & Solutions:

• Use only dishwasher-specific detergent.
• Reduce detergent quantity if using soft water.
• Run an empty rinse cycle to clear excessive suds.

Issue:- Water fills above the normal level, triggering automatic drainage.

Possible Causes & Solutions:

• Faulty water inlet valve – Close the water faucet and contact a technician.
• Defective water level sensor – Schedule a service appointment.
• Restart the dishwasher after turning off the power for 5 minutes.

Issue:- Thermistor resistance output abnormal.

Possible Causes & Solutions:

• Unplug the dishwasher for 10 seconds and restart.
• If the issue persists, replace the thermistor.

Issue:- Water is not heated or the temperature exceeds 194°F.

Possible Causes & Solutions:

• Faulty heating element – Contact an authorized technician.
• Overheating due to sensor malfunction – Restart the dishwasher and monitor performance.

Issue:- Motor is not functioning properly.

Possible Causes & Solutions:

• Overloaded dishwasher – Reduce load and restart.
• Motor blockage – Check for obstructions in the pump area.
• Contact a technician if the error persists.

Issue:- Position of the Vario cam is incorrect.

Possible Causes & Solutions:

• Restart the dishwasher to reset the sensor.
• If the problem continues, schedule a service check.